Size Guide
Belts
The most reliable way to measure belt size is to measure an existing belt. Measure from the tip of the buckle to the hole you use. Our belts have seven holes. The size you order will be to the middle hole. It doesn’t matter if you wear your old belt in the first or last hole, we will make your new belt to measure to the middle hole.
If you don't have a belt, use a flexible tape to measure through the loops of your jeans or pants while wearing them.
​
Jean and pant sizes vary greatly but as a general rule you add 2 inches or 5 centimetres. For example, your jean size in 34 inches you should order at least a 36 inch belt. Please note that this can be unreliable and note our return policy when ordering customised belts.
​
Use the below conversion table to determine which belt size to order. The measurement is from the tip of the buckle to the middle hole.
​
66 cm - order a 26" belt
71 cm - order a 28" belt
76 cm - order a 30" belt
81 cm - order a 32" belt
86 cm - order a 34" belt
91 cm - order a 36" belt
96 cm - order a 38" belt
102 cm - order a 40" belt
107 cm - order a 42" belt
112 cm - order a 44" belt
117 cm - order a 46" belt
​
Please make contact here to enquire about smaller belts.
Dog Collars
Dimensions:
Small – holes between 35 and 45 cm
Medium – holes between 40 and 50cm
Large – holes between 45 and 55 cm.
Our dog collars have six holes which are 20mm apart.
When selecting the correct size, measure the circumference of your dog’s neck with a little room for comfort. This can be measured using a soft tape, or by measuring your dog’s existing collar. Measure from the most used hole, to the tip of the buckle. Please then choose a size from the ranges above which allows for a hole or two each side of your dog’s neck size.
​​
Please make contact if you would like a dog collar with different dimensions here.